Osburn AC01343 Manual do Utilizador Página 1

45770A 07-10-2014 HOT AIR DISTRIBUTION KIT AC01343 INSTALLATION INSTRUCTIONS Stove Builder International Inc. 250, rue de Copenhague Saint-Au

10 Example of a system installation In regards to part (I) there are three different products you can use for your installation: sem

2 This hot air distribution kit contains the following parts: (A) –SE67185 (B) –SE67190 2x 2x (C) -PL67194 For models with semi-full grill: (

3 Other required parts (not included): WARNING: All parts used must be at least 325°F resistant. (H) Angled elbow, depending on your needs*

4 1 Remove the bottom decorative panel of the stove (steps 1-4 must be repeated for the left and right side of the stove). 2 U

5 3 Remove the decorative front stove grill (set aside). Unscrew (wrench 5/16'') and remove the cap of the hot air outlet from the front.

6 4 Install and secure the 5’’ adapter (B) to the rear or side of the hot air outlet using 4 screws (E). Please note that it is possib

7 5 (for models with full grill) To install the plate with the fold in the middle (D), you should first put the hook screws (G) as shown below. Ins

8 5 (for models with semi-full grill) To install the plate (C), you should first put the hook screws (G) as shown below. First slide the hook screws

9 WARNING: During the installation, you must maintain a minimum of 1" clearance to combustible materials on the entire length of the system.