Osburn OB01801 Manual do Utilizador descarregar pdf (Página 15)

/15

2.8 Connector installation

A masonry flue connector may provide acceptable performance (Figure 2.8a); however, we recommend

the use of a chimney liner (rigid or flexible) to ensure satisfactory performance (Figure 2.8b). To ensure

an optimal draft, we also strongly recommend adding a minimum of 18” rigid liner between the roof

flashing and the rain cap. Slip connectors for continuous liners should also be installed. Use Listed

Chimney Liners – UL1777, CAN/ULC-S635.

Figure 2.8a* Figure 2.8b*

Generic illustrations. The model of your insert can differ from the one shown above.

ATTENTION INSTALLER: When positioning the unit in a fireplace opening prior to the flue

installation, install the insert into the opening until the top lip of air jacket is flush with fireplace

facing.

If lag-bolts and anchors are to be used to secure the insert, the whole locations should be marked

with the unit in place. Remove the insert and locate the anchors.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Sem comentários

Osburn OB01801 Manual do Utilizador Página 15